Which command will take the static default route and inject it in the OSPFv3 database?

Which IPv6 command allows you to verify general parameters such as the reference bandwidth?

Which priority value should you set for a switch to give it the best chance of remaining as a root bridge in the long term?

Four OSPF routers connect to the same LAN. In a new election after all routers have been rebooted, which router wins the DR election?

Which technology do we use to turn the public Internet into a private secure environment?

Which cloud service model is primarily targeted toward the software development community and provides the ability to not only customize the hardware being virtualized but also offer different development tools and utilities that are commonly used for a specific environment?

To connect a Cisco wireless LAN controller to a wired network, which of the following would you use? Assume that this connection will carry traffic to and from APs.

enable secret [password]​ is hashed using the _______ algorithm.

You are configuring port security on a Catalyst IOS switch. You need to choose a violation mode that will deny frames that are in violation of the port security settings while still allowing frames that are not in violation. In addition, syslog messages need to be generated and the port security violation counter must increase each time a violation occurs.
Which port security violation mode should you choose?

Connections can be verified using a variety of troubleshooting commands. Which of the following commands is used to display incoming and outgoing connections?

Within a deny statement for an IPv6 ACL, what are the possible values for the prefix? (Choose two)

Which command will assign a static link-local address to an interface?

An enterprise plans to start using a public cloud service and is considering different WAN options. The answers list four options under consideration. Which one option has the most issues if the company chooses one cloud provider but then later wants to change to use a different cloud provider instead?

Your router has learned about the network 172.17.8.0/24 from EIGRP and OSPF.
What information will the router populate the routing table with?

Please choose the correct sequence of the following data encapsulation steps:
1. The layer 3 header is added to the data before being passed on the next layer.
2. A header is added to previous data and is passed to the Internet layer.
3. A trailer, usually the frame check sequence of FCS, and a header are added.
4. An application sends user data.

When planning a greenfield SDA design, what traditional LAN design points should be included? (Choose two)

The CLI is used to enter commands. Identify the command entry functions of the Cisco CLI. (Choose two)

You can use output filters in combination with any show command. Which of the following shows all output lines that match the filtering expression?

A poorly designed network typically includes which of the following? (Choose three)

What are some perceived benefits of controller-based networks as compared to traditional networks? (Choose two)

Which of the following describes a multicast type of network communication?

What guidelines must be followed to successfully form an EtherChannel bundle? (Choose two)

Which Cisco IOS command is used to advertise a default route into an OSPF domain regardless of whether a default static route is configured?

Refer to the diagram. What is the official name of the network (Network A) that is broadcast by an AP?

Which options are not one of the manageable QoS characteristics of network traffic? (Choose two)

A switch’s port Gi0/1 has been correctly enabled with port security. The configuration sets the violation mode to restrict. A frame that violates the port security policy enters the interface, followed by a frame that does not. Which of the following answers correctly describe what happens in this scenario? (Choose two)

Regarding lightweight AP modes, which one of the following is true?

Which features are used to extend the lifetime and usefulness of IPv4 networks? (Choose four)

What protocols exist to negotiate EtherChannel creation and maintenance? (Choose two)

What commands would you need to configure to enable DHCP Snooping so that PC4 couldn’t become a rogue DHCP server?

Where is the start-up configuration file stored and loaded from by default on a Cisco IOS router?

Which statements reflect the operation of OSPF neighbor states? (Choose two)

Which QoS feature is typically used inbound to a network to limit the amount of traffic that is allowed to flow in?

In what security zone are the public web servers located?

Review the topology diagram. Network 10.123.0.0/24 is the backbone area. Network 10.12.0.0/24 is area 1, and network 10.34.0.0/29 is in area 2. Which of the following are true? (Choose three)

You are using CDP to build a network topology.
Which command is used to verify the IPv4 address of the neighboring Cisco IOS device?

Which of these are QoS requirements when designing a Cisco voice network? (Choose two)

Which of the following controllers (if any) from Cisco uses a mostly centralized control plane model?

Which of the following options are provided by private VPNs? (Choose two)

Which command displays information about security options configured on an interface?

Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?

Think about a policing function that is currently working, and also think about a shaping function that is also currently working. That is, the current bit rate of traffic exceeds the respective policing and shaping rates. Which statements are true about these features? (Choose two)

You want to disable the negotiation of trunking for all FastEthernet ports.
Which commands are required to do this? (Choose two)

Which of the following cloud services is most likely to be purchased and then used to later install your own software applications?

When comparing controller-based networks and traditional networks what are some perceived benefits from a controller-based perspective? (Choose two)

You have an IP address of 192.168.1.2/25. What are the subnet ID, broadcast address, and usable range of this subnet?

What are the functions of switches? (Choose three)

Which RFC defines the private IPv4 address ranges?

Which IOS command always displays OSPF hello timer settings?

Identify characteristics of switches. (Choose three)

What will happen if a private IP address is assigned to a public interface connected to an ISP?

In a split-MAC architecture, real-time functions such as encryption are handled in which of the following network entities?

Which protocol number represents ICMPv6?

You are currently building a network diagram. You need to add the model number of the local device you are connected to in the diagram.
Which command will provide you with the model number of the local Cisco IOS device?

Host A and Host B sit in two different subnets. The path between the subnets of these two hosts runs through three different Layer 3 forwarding devices (routers and Layer 3 switches). A network engineer uses the APIC-EM Path Trace ACL Analysis tool to analyze the path used for Host A to send packets to Host B. Which part of the function is done specifically by the ACL Analysis or ACL Trace part of the tool?